da Vinci Jr. 1.0 – Filament not Sticking or Cutting into the Print Bed? Check your Z Offset

da Vinci Jr. 1.0 – Filament not Sticking or Cutting into the Print Bed? Check your Z Offset


da Vinci Jr.1.0 – Filament not Sticking or Cutting into the Print Bed? Check your Z Offset If you’re encountering the following issues Such as the gap between the nozzle and platform is too short So that the tape is scratched by the nozzle or making a clicking sound The gap between the nozzle and platform is too much The base of the print out cannot be formed Please adjust the print module by using the “Z OFFSET” (print module adjustment) function Select “UTILITIES” followed by selecting “Z OFFSET” (print module adjustment) This function is used to adjust the gap between the print nozzle and the print bed Before adjusting the Z axis, record the original Z OFFSET value first The recommended distance between the nozzle and print bed(with bed tape securely fastened) should allow two sheets of A4 paper to be drawn out smoothly Increase/decrease the value based on a scale of 0.1mm Increasing the value will increase the gap between the print module and print bed by 0.1mm Decreasing the value will also decrease the gap between the print module and print bed by 0.1 mm If the gap between the nozzle and platform is too short then add to the Z Offset to move the nozzle up If the gap between the nozzle and platform is too much then add to the Z Offset to move the nozzle down Perform test prints before considering further adjustments Press “OK” to end adjustment of print module. Select “Home Axes” Select “YES” Once the nozzle returns to Home Axes Press “OK” The Z Offset adjustment of da Vinci Jr. 1.0 is now complete www.xyzprinting.com

Leave a Reply

Your email address will not be published. Required fields are marked *